Annealing
From cutting-edge technology to personalized support, we ensure accuracy and efficiency in every solution
Steel Industry
Application
Bright Annealing Process of Stainless-Steel Tube
Bright annealing is a critical production process. If proper annealing is not done tube surface can crack, stained, and may lead to easy corrosion. In this process the stainless tube is heated to high temperatures in presence of inert gases. Annealing is done to reduce the hardness of the steel to attain ductility for further processing.
The tube comes out of welding, sizing, and degreasing unit and finally enters the closed annealing chamber. In the closed annealing chamber, the stainless tube is heated to high temperature by induction coils in reducing atmosphere of inert gases like Argon/Nitrogen and Hydrogen gas. After some time, the red-hot tube exits from the closed annealing chamber and is subjected to rapid cooling. After the tube exits the chamber, it finally goes into the last stages of sizing and straightening.
The following factors are important for effective bright results of the tube.
- The surface of the tube must be thoroughly cleaned to remove foreign particle if present any before entering the annealing process
- The surface of the tube must be thoroughly cleaned to remove foreign particle if present any before entering the annealing process. The atmosphere surrounding the annealing process should be free from Oxygen. For this a vacuum is created or by carrying the process in presence of dry hydrogen or argon.
Recommended :
A 450C TL
Temperature range : 600°C to 2500°C
The monitoring of the tube temperature is essential for
Effective Bright Surface Finish
To strengthen and maintain a strong internal bond of the stainless tube.
Heating as fast as possible. Slow heat results in oxidation at intermediate temperatures. Higher temperatures produce reducing condition which is very effective for the final brighter appearance of the tubes. The peak temperature maintained in the annealing chamber is around 1040°C.
Solution to the Application
AST Pyrometer model A250/A450/A250+/A450+ is suited for this application. The AST A250/A450/A250+/A450+ is mounted over the safety glass-protected observation window of around 10mm thickness. The Pyrometer is wired to a temperature indicator which shows the temperature of the tube leaving the induction coil.
Installation of our AST Pyrometer system at Annealing chamber plant.
The electronic assembly is protected by IP65 rugged stainless-steel housing. The pyrometer is provided with “Infrasoft” PC software for remote data logging and parameter setting. Pyrometer has user selectable analogue output 0/4…20mA, 0…10V and digital output RS-232 and RS-485. When connected to PC using USB port, pyrometer works stand-alone without any external power supply.
Recommended :
